Installation Guide
How to Attach Your Mounts
Two ways to Mount / Everything Included / No Guesswork
Mount Option: Screw-in (Permanent)
Step 1
Plan Your Display
Step 2
Mark Your Wall
Step 3
Drill Pilot Holes
Step 4
Install Wall Plugs
Step 5
Mount and Secure
Step 6
Display Your Foam Dart Blaster
Mount Option: Screw-In (Permanent)
Displayed Above
Best For: Permanent, heavy-duty installs on uneven walls (brick, plaster, concrete)
Benefits: Strong and Secure Hold
Tools and Items Required:
• Drill
• 1/4 inch drill bit
• #2 Phillips screwdriver
• Wall plugs #8 (25 lbs) – included
• Screws #8 – included
• Pencil
Installation Steps:
Step 1: Plan Your Display
• Focus on spacing and positioning before drilling.
Step 2: Mark Your Wall
• Hold your foam dart blaster with one hand where you want it mounted.
• With your other hand, use a pencil to mark where your mounts will best support the
blaster.
• Then, hold the resting edge of your mount at the pencil line and mark the two screw
holes.
Step 3: Drill Pilot Holes
• Drill 1/4 inch pilot holes at the marked spots.
Step 4: Install Wall Plugs
• Insert the provided wall plugs into the holes until flush.
Step 5: Mount and Secure
• Using a screwdriver, screw the mount into place with the provided screws.
• Tighten securely — do not overtighten.
Step 6: Display Your Foam Dart Blaster
• Your mount is ready immediately — no wait time needed.
Mount Option: Adhesive (Removeable)
Best For: Damage-free installs on smooth walls
Benefits: No tools required / Clean, easy install
Items Required:
• Double-sided adhesive – Included
• Pencil
Installation Steps:
Step 1: Plan Your Display
• Focus on spacing — once installed, mounts are not adjustable.
Step 2: Clean the Surface
• Ensure the surface is free from dust and oils.
• If needed, wipe with dish soap and let dry for 20 minutes.
Step 3: Mark Your Wall
• Hold your foam dart blaster with one hand where you want it mounted.
• With your other hand, use a pencil to mark where your mounts will best support the
blaster.
Step 4: Prepare the Mount
• Peel off the red side of the adhesive and press it firmly onto the back of the mount.
Step 5: Attach to Wall
• Peel off the white side of the adhesive.
• Line up the resting edge of your mount with the pencil line and press it FIRMLY onto
the wall.
• Hold for at least 10 seconds.
Step 6: Set Time
• Allow adhesive to cure for 12 hours before hanging your blaster.